This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Qos mbit/s or kbit/s ???

Hello, Reading the QOS Guide from here and also Reading QOS Section under "Help" it should be kbit/s for bandwith on interfaces that have to be set correctly for QOS.

But if i go QOS > Status i see that all the interfaces have Default 1024 mbit/s 

So it is correct that if a have an 50mbit/s down and 6mbit/s up on My WAN Interface i do select it like on my picture?

[:S]

Thank you


This thread was automatically locked due to age.
  • Yes, that's correct.

    If you make any Download Throttling rules, do not select 'Download-Ausgleich'.  Similarly for 'Upload-Optimierung' if you make Bandwidth Pools to prefer certain outbound traffic.

    Cheers - Bob
  • Thank you Balfson,

    i just want to reserve 2mbit/s for Voip Traffic, because a customer is complaining about quality of Voice over IP. so i think reserving 2mbit will be enough. 

    Or would you say i should do it better with an Voip Helper?

    Yes, that's correct.

    If you make any Download Throttling rules, do not select 'Download-Ausgleich'.  Similarly for 'Upload-Optimierung' if you make Bandwidth Pools to prefer certain outbound traffic.

    Cheers - Bob
  • Hi,

    My past experience with the VOIP proxy is that you need QoS as well.

    Barry
  • Every time I've been involved with complaints about voice quality over VoIP, it was either Anti-DoS UDP Flooding or a misconfiguration by the VoIP provider.  Check #1 in Rulz.  Any luck?

    Cheers - Bob
  • This troubles where there before i installed Sophos sg 230 Cluster, it´s just comes sometimes i suggest when there is much traffic, that VoIP calls get disconnected for no Reason. So the customer want me to try QOS. 

    i will se if that helps. Do i have to reserve 2mbit/s for Download direction to? or Upload will be enough?

    Every time I've been involved with complaints about voice quality over VoIP, it was either Anti-DoS UDP Flooding or a misconfiguration by the VoIP provider.  Check #1 in Rulz.  Any luck?

    Cheers - Bob
  • This troubles where there before i installed Sophos sg 230 Cluster, it´s just comes sometimes i suggest when there is much traffic, that VoIP calls get disconnected for no Reason. So the customer want me to try QOS. 

    i will se if that helps. Do i have to reserve 2mbit/s for Download direction to? or Upload will be enough?


     I  recommend using the auto QOS on all interfaces though as it does a very good job at making sure that if something is hogging your download it will slice up room needed for other traffic.  This in conjunction with the other qos you are working with should fix your issue barring a configuration or hardware problem.
  • Hello William,

    thank for the advice. so you mean i shouldn´t reserve some bandwith for Voip Traffic at all? or should i use Automatic QOS together with Reserving some Bandwith for VoiP traffic?

    I  recommend using the auto QOS on all interfaces though as it does a very good job at making sure that if something is hogging your download it will slice up room needed for other traffic.  This in conjunction with the other qos you are working with should fix your issue barring a configuration or hardware problem.
  • in terms of upload most assuredly reserve the proper bandwidth in terms of download though you can try to reserve bandwidth but the auto qos typically handles it well...[:)]
  • Holy, VoIP problems are usually caused by Anti-UDP-Flooding activity.  Look in the Intrusion Prevention log.

    Cheers - Bob
  • BAlfson,

    i didn´t activate any. as i said, the problem was there before Sophos. i activated now QOS for Upload from LAN > Internet Reserverd Bandwith + Automatic Download QOS. 

    I will report if that solve the issue.

    Holy, VoIP problems are usually caused by Anti-UDP-Flooding activity.  Look in the Intrusion Prevention log.

    Cheers - Bob