This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

9.101 overwrote 9.100?

Hi there,

Since yesterday evening I try to update a cluster of two UTM 220 from 9.005 to 9.1. With the master I succeeded but the slave was on state UP2date for several hours.
Today I factory resetted the slave and tried to update it manually. This was successful with 9.006 but the downloadable file u2d-sys-9.100016-101012.tgz.gpg shows up as 9.101 and generates an error messages like "9.100 was expected but 9.006 is installed" -> up2date failed!
Also, a reconnect of the two results in eternal UP2DATE state of the slave...

Any suggestions how I can get the two nodes on the same firmware?

Thanks a lot,
Uli

This thread was automatically locked due to age.

0 scorpionking over 12 years ago
The Up2Date files are "incremental", so you have to upload the whole chain. Based on 9.006-5 this would be:

u2d-sys-9.006005-100016.tgz.gpg
u2d-sys-9.100016-101012.tgz.gpg
Cancel
Vote Up 0 Vote Down

Cancel
0 UliSa over 12 years ago in reply to scorpionking

Thanks, scorpionking,

I know, but the file named u2d-sys-9.100016-101012.tgz.gpg appears as 9.101-12 on the firewall and is only 48MB.
There is no "real" 9.100 file available anymore and that's my problem.
Cancel
Vote Up 0 Vote Down

Cancel
0 scorpionking over 12 years ago in reply to UliSa
You have to read the newer Up2Date file names as following:
u2d-sys--.tgz.gpg

So the u2d-sys-9.006005-100016.tgz.gpg will update from 9.006005 to 9.100016. And that means: you need both the files I mentioned above... [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 UliSa over 12 years ago

Ah, ok, this should solve my problem... :-)
Sorry for the stupid question!
Cancel
Vote Up 0 Vote Down

Cancel
0 scorpionking over 12 years ago in reply to UliSa

There are no stupid questions, only stupid answers... [;)]
Maybe this helps someone else in the future...
Cancel
Vote Up 0 Vote Down

Cancel
0 UliSa over 12 years ago

Yes, that could happen.... ;-)

Thanks a lot!
Cancel
Vote Up 0 Vote Down

Cancel