This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASG 7GA installation problems

i have a dell optiplex gx270 with 4 nics installed. 2gb ram. 80gb hd

after the latest step it comes with the following error.

installation failed

please remove cd-rom and restart the system.

when i check the log file i see the following

phase start: install
checking md5 sums
sh: line 0: cd: /install/install/: no such file or directory
/usr/bin/md5sum/: install.md5: no such file or directory
return code: 256
Phase end: install (ret=0)
 umount: /dest//sys: no such file or directory
 umount: /dest//proc: no such file or directory
 umount: /dest//boot: no such file or directory
 umount: /dest//opt/inst: no such file or directory
 umount: /dest//var/storage: no such file or directory
 umount: /dest//var/log: no such file or directory
 umount: /dest//tmp: no such file or directory
 umount: /dest//: invalid argument

dont know what the problem is. 
i tried with a different cd burned with lower speed.
different hd
checked the memory
removed 2 nics.


This thread was automatically locked due to age.
Parents
  • Sorry to tell, but whilst trying to install the v7 I experience the same problem.
    It says installation failed. remove disc and restart.

    What's this about?

    I tried with 2 different computers, with 3 different cd drives and 1 cd burning device. I tried with 3 different harddrives.

    Following log entries on console 3:

    /usr/bin/md5sum: WARNING: 9 of 343 listed file could not be read
    Return code: 256
    PHASE END. install (ret=0)
    and then some:  umount: /dest//sys No such file and directory
    ... and such stuff

    So it still didn't work out. Please help!

    Michael
  • Guys are you both using SATA drives?
  • Hi Mike,

    Guys are you both using SATA drives?


    my solution was that I had to burn the iso-image only with 8x speed, not with maximum speed.
    Then the installation worked...

    Michael

    [EDIT]BTW: I'm just using normal ATA drives[/EDIT]
  • ah  the dreaded burning issues....
  • Yes ,
    is the same for some HW conf. from version 3 : burn the install cd at lower speed you can and install at lower speed too.
    ciao e miao  micio
  • Guys are you both using SATA drives?


    Yes I am using a SATA drive and it says no bootable drive found? What can I do now?
  • Had the same issues trying to install on a Sony VAIO RX538

    Return code 256 
    unable to mount file systems

    What worked for me was the following

    a.) burn the ISO at the lowest burn rate possible; ISO burning software was DeepBurn
    b.) Disconnect my slave CDROM drive
    c.) In the BIOS set my HD to manual and use LBA

    After these changes the install went like clock work.
Reply
  • Had the same issues trying to install on a Sony VAIO RX538

    Return code 256 
    unable to mount file systems

    What worked for me was the following

    a.) burn the ISO at the lowest burn rate possible; ISO burning software was DeepBurn
    b.) Disconnect my slave CDROM drive
    c.) In the BIOS set my HD to manual and use LBA

    After these changes the install went like clock work.
Children
No Data