Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 2 subscribers
  • Views 357 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem installing ASL on a VIA C3 box

mrj
I tried to install ASL 5.202 on a small box but it hangs during "Hardware is beeing detected". What can i do, to get it running? I already tried 4.008 which I had on hand - same result.

System configuration as follows:
Mainboard LExSystems CV860A
CPU VIA C3 533 MHz Low Power (Eden)
Chipset VIA PLE133 (VT8601A, VT82C686B) with integrated S3 Graphics
RAM 256 MB PC133 SDRAM
HDD 40 GB Samsung 2.5"
NIC 3x Realtek 8100B


This thread was automatically locked due to age.
Parents
  • 0
    The LEX Light box works okay at least until 5.050 or something - haven't tried with 5.200. The NICs are perhaps different from my setup, but that shouldn't be a problem. Did you try using another CD drive, that could sometimes cause a problem too?
  • 0 in reply to MagicMike
    Thanks for your suggestions. Indeed it's a LEX Light box.
    As you're using a similar configuration, please could you specify bios settings you changed?
    So I go fetch the 5.000 cd from work this afternoon and then I'll give it another try. Maybe I should try a different cd-rom drive first.
Reply
  • 0 in reply to MagicMike
    Thanks for your suggestions. Indeed it's a LEX Light box.
    As you're using a similar configuration, please could you specify bios settings you changed?
    So I go fetch the 5.000 cd from work this afternoon and then I'll give it another try. Maybe I should try a different cd-rom drive first.
Children
Cookie Information Banner