Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NIC Trouble

Hi Everybody,

I got three Intel EtherExxpress 100 Pro NICs with 82559 Chipset in my ASL box. Somehow the ASL is unable to correctly detect the NICs since in the WebAdmin Bus, IRQ,... are unknown.
I suspect that these NICs are too new to correctly detected by ASL. Are any new modules available or can I use modules by debian ?

Thanks in advance

Fiazko


This thread was automatically locked due to age.
Parents
  • Hello,

    Some questions:

    which ASL version do you use?

    Does the install routine recognise the NICs?

    Thank you,
    --
    Dennis

    [ 18 July 2001: Message edited by: Dennis Koslowski ]
  • Hi,

    I use ASL 1.822

    The NICs are detected during installation.

    I tried setting up a fixed IRQ for the PCI slots in BIOS, without any success.
  • I have similar problem with Intel 82820 Chipset. The interface is not recognised at installation. The /proc/pci shows however the device:


        Ethernet controller: Intel Corporation 82820 820 (Camino 2) Chipset Ethernet (rev 1).
          IRQ 7.
          Master Capable.  Latency=64.  Min Gnt=8.Max Lat=56.
          Non-prefetchable 32 bit memory at 0xefdfe000 [0xefdfefff].
          I/O at 0xb400 [0xb43f].
Reply
  • I have similar problem with Intel 82820 Chipset. The interface is not recognised at installation. The /proc/pci shows however the device:


        Ethernet controller: Intel Corporation 82820 820 (Camino 2) Chipset Ethernet (rev 1).
          IRQ 7.
          Master Capable.  Latency=64.  Min Gnt=8.Max Lat=56.
          Non-prefetchable 32 bit memory at 0xefdfe000 [0xefdfefff].
          I/O at 0xb400 [0xb43f].
Children