This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NIC Trouble

Hi Everybody,

I got three Intel EtherExxpress 100 Pro NICs with 82559 Chipset in my ASL box. Somehow the ASL is unable to correctly detect the NICs since in the WebAdmin Bus, IRQ,... are unknown.
I suspect that these NICs are too new to correctly detected by ASL. Are any new modules available or can I use modules by debian ?

Thanks in advance

Fiazko

This thread was automatically locked due to age.

0 Dennis Koslowski over 23 years ago

Hello,

Some questions:

which ASL version do you use?

Does the install routine recognise the NICs?

Thank you,
--
Dennis

[ 18 July 2001: Message edited by: Dennis Koslowski ]
Cancel
Vote Up 0 Vote Down

Cancel
0 Fiazko over 23 years ago in reply to Dennis Koslowski

Hi,

I use ASL 1.822

The NICs are detected during installation.

I tried setting up a fixed IRQ for the PCI slots in BIOS, without any success.
Cancel
Vote Up 0 Vote Down

Cancel
0 jts over 23 years ago in reply to Fiazko

I have similar problem with Intel 82820 Chipset. The interface is not recognised at installation. The /proc/pci shows however the device:

    Ethernet controller: Intel Corporation 82820 820 (Camino 2) Chipset Ethernet (rev 1).
      IRQ 7.
      Master Capable.  Latency=64.  Min Gnt=8.Max Lat=56.
      Non-prefetchable 32 bit memory at 0xefdfe000 [0xefdfefff].
      I/O at 0xb400 [0xb43f].
Cancel
Vote Up 0 Vote Down

Cancel
0 Dennis Koslowski over 23 years ago in reply to jts

For Fiazko and jts:

please post the reesults of:

cat /proc/pci/devices | awk '{print $2}'

Thank you,
--
Dennis
Cancel
Vote Up 0 Vote Down

Cancel
0 Dennis Koslowski over 23 years ago in reply to Dennis Koslowski

For jts:

it's strange, your card is supported and should be recognized during installation... which version did you try to install?
--
Dennis
Cancel
Vote Up 0 Vote Down

Cancel