Cannot get Captive Portal to function

Joe,

make sure to configure a top firewall rule where "match know user and show captive portal to unknow users" are checked.

Captive portal works on 8090 by default.

You can change captive portal settings under Authentication > Services.

Regards

This is what I have for the rule, again, created from the document.

Joe,

captive portal is enabled only on LAN by default. Check the configuration under Administration > Device Access > Captive Portal Column.

Regards

So this cannot be enabled on the WAN side?

Maybe I'm approaching this the wrong way -- what I want to accomplish is have external users load a web page, authenticate, and have VPN installed from that page.

Am I doing this incorrectly?

Joe,

you are looking for User Portal. By default User Portal is active on port https://wan ip . You can enable it under Device Access and change the port under Device Settings in the same Administration menu.

Regards

Joe,

you are looking for User Portal. By default User Portal is active on port https://wan ip . You can enable it under Device Access and change the port under Device Settings in the same Administration menu.

Regards

Luk,

Thank you for pointing this out. I was getting confused between the two. I should be all set now.

Thanks,

Joe