Guest User!

You are not Sophos Staff.

Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 6 replies
  • Subscribers 26 subscribers
  • Views 4364 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problems to configure High availability

Ruflex

Hi! i have 2 Sophos SG230 whit SFOS 18.0.3 MR-3.

I configure high availability in active-pasive mode, whit the same key in the 2 firewalls. I configure the second firewall in auxiliary and conects all cables to firewalls.

When initiate ha, the primary firewalls show "HA could not be enabled"

I run this command in advanced shell: cat /log/applog.log | grep "ha:"

Nov 26 11:56:49 Validation Failed For Ha interface IP

Nov 26 11:56:49 ha: pollenableha: enableha failed

how i can fix this problem?? Thanx



This thread was automatically locked due to age.
Parents
  • FormerMember
    0 FormerMember

    Hi ,

    Thank you for reaching out to the Community! 

    The error in applog.log indicates that there could be an issue with the current interface configuration on the primary unit. Is there any LAG interface on the primary unit? If yes, try to configure it on the secondary unit and then try to enable HA. 

    Thanks,

Reply
  • FormerMember
    0 FormerMember

    Hi ,

    Thank you for reaching out to the Community! 

    The error in applog.log indicates that there could be an issue with the current interface configuration on the primary unit. Is there any LAG interface on the primary unit? If yes, try to configure it on the secondary unit and then try to enable HA. 

    Thanks,

Children
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?