Can't open port 443 and 80

Hi David,

Welcome to the Sophos Community!

It looks like you may have accidentally specified your internal interface for the "destination host/network". If you are creating a DNAT rule for the purpose of redirecting incoming WAN traffic to your LAN/internal client, you will need to select your external WAN IP for this.

Regards,

Hey,

thanks for the quick answer. I actually made that mistake but even with that it is not working.

I am not quite sure, what you are trying to archive. 

You want to "expose" Port 80 and Port 443 of your PteroServer to the Internet? 

Is Port1 your WAN Port? 

Source - Destination is the Traffic BEFORE the NAT hits. 

Forward to - is the "action", which XG takes. 

Therefore Port1 has to be your WAN Port. 

Sorry if I wasn't clear enough, yes I'm trying to expose Port 80 and 443 of the PteroServer.

For whatever reason while installing (running inside of a Hyper-V VM) Port 1 is the LAN Port and port 2 is the WAN Port.

Port 1 is connected to my switch and the rest of the network.

Port 2 is the WAN port connected to my router which is treating the firewall as exposed host so all traffic on any port is routed through to the firewall.

Sorry if I wasn't clear enough, yes I'm trying to expose Port 80 and 443 of the PteroServer.

For whatever reason while installing (running inside of a Hyper-V VM) Port 1 is the LAN Port and port 2 is the WAN Port.

Port 1 is connected to my switch and the rest of the network.

Port 2 is the WAN port connected to my router which is treating the firewall as exposed host so all traffic on any port is routed through to the firewall.

I found the issue...buried in some sub menu of a sub menu the FirtzBox was set to listen on port 443 for remote access...everything is working now.

Thanks anyway!