Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 28 subscribers
  • Views 8368 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't open port 443 and 80

David Kühlmann

Well...hello, I'm quite new to the XG Firewall and hope someone can help me.

So, my problem is that I can't open port 80 and 443 in my firewall.

I have attached the config I used. If anybody has a clue what is wrong please tell me.



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to David Kühlmann

    I am not quite sure, what you are trying to archive. 

    You want to "expose" Port 80 and Port 443 of your PteroServer to the Internet? 

    Is Port1 your WAN Port? 

     

    Source - Destination is the Traffic BEFORE the NAT hits. 

    Forward to - is the "action", which XG takes. 

     

    Therefore Port1 has to be your WAN Port. 

  • 0 in reply to LuCar Toni

    Sorry if I wasn't clear enough, yes I'm trying to expose Port 80 and 443 of the PteroServer.

    For whatever reason while installing (running inside of a Hyper-V VM) Port 1 is the LAN Port and port 2 is the WAN Port.

    Port 1 is connected to my switch and the rest of the network.

    Port 2 is the WAN port connected to my router which is treating the firewall as exposed host so all traffic on any port is routed through to the firewall.

  • 0 in reply to David Kühlmann

    I found the issue...buried in some sub menu of a sub menu the FirtzBox was set to listen on port 443 for remote access...everything is working now.

    Thanks anyway!