Can't open port 443 and 80

Hi David,

Welcome to the Sophos Community!

It looks like you may have accidentally specified your internal interface for the "destination host/network". If you are creating a DNAT rule for the purpose of redirecting incoming WAN traffic to your LAN/internal client, you will need to select your external WAN IP for this.

Regards,

Hi David,

Welcome to the Sophos Community!

It looks like you may have accidentally specified your internal interface for the "destination host/network". If you are creating a DNAT rule for the purpose of redirecting incoming WAN traffic to your LAN/internal client, you will need to select your external WAN IP for this.

Regards,

Hey,

thanks for the quick answer. I actually made that mistake but even with that it is not working.

I am not quite sure, what you are trying to archive. 

You want to "expose" Port 80 and Port 443 of your PteroServer to the Internet? 

Is Port1 your WAN Port? 

Source - Destination is the Traffic BEFORE the NAT hits. 

Forward to - is the "action", which XG takes. 

Therefore Port1 has to be your WAN Port. 

Sorry if I wasn't clear enough, yes I'm trying to expose Port 80 and 443 of the PteroServer.

For whatever reason while installing (running inside of a Hyper-V VM) Port 1 is the LAN Port and port 2 is the WAN Port.

Port 1 is connected to my switch and the rest of the network.

Port 2 is the WAN port connected to my router which is treating the firewall as exposed host so all traffic on any port is routed through to the firewall.

I found the issue...buried in some sub menu of a sub menu the FirtzBox was set to listen on port 443 for remote access...everything is working now.

Thanks anyway!