This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro VPN to eLux VPNC

Hello,

i have an little ASG110 with v8.3 and want a VPN tunnel to one Fujitsu Thinclient (A300).
The OS on the Thinclient is eLux 3.7.0
In the datasheet stands that there four VPN clients included. But it is only one, the VPNC. The productmanagment do the decision to cancel the support of other clients... [:@]

Now it is "my" part to configure that, but i'm not the VPN pro and hope that somebody can help me al little bit.

Which VPN should i use?
And how to configure in the client?

I need a little push in the right way. [;)]

Thanks!

Kev

[SIZE="1"]PS: Sorry for my bad englisch, not my day...[:(][/SIZE]

This thread was automatically locked due to age.

Parents

0 BarryG over 13 years ago

Hi, VPNC is a Cisco VPN client.

IIRC, Astaro has a Cisco VPN mode, so you could try it with that.

Otherwise, I would recommend googling or contacting Fujitsu and asking for other VPN clients.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 Kev HA over 13 years ago in reply to BarryG
Hello,

VPNC is a Cisco VPN client.

that VPNC is a free linux based pakage and not the Cisco client. Maybe, they have some common characteristics, but it is not the original Cisco client.

Here my Tests...

The IPSec config with Preshared Key...

And the policy...

My VPNC config:
IPSec gateway ip.dyndns.biz
IPSec ID ThinClient
IPSec secret password
Xauth username guenther
Xauth password password
DPD idle timeout (our side) 0
Enable Single DES

I got a connection to the Astaro but the client gives an error...

response was invalid [1]: (ISAKMP_N_INVALID_EXCHANGE_TYPE)(7)

I googled but with no result, can somebody look at my config?

Thanks!

Kev
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Kev HA over 13 years ago in reply to BarryG
Hello,

VPNC is a Cisco VPN client.

that VPNC is a free linux based pakage and not the Cisco client. Maybe, they have some common characteristics, but it is not the original Cisco client.

Here my Tests...

The IPSec config with Preshared Key...

And the policy...

My VPNC config:
IPSec gateway ip.dyndns.biz
IPSec ID ThinClient
IPSec secret password
Xauth username guenther
Xauth password password
DPD idle timeout (our side) 0
Enable Single DES

I got a connection to the Astaro but the client gives an error...

response was invalid [1]: (ISAKMP_N_INVALID_EXCHANGE_TYPE)(7)

I googled but with no result, can somebody look at my config?

Thanks!

Kev
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data