This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Locking user to specific hosts in Remote Access

I know this is probably a typical Newbie type question -

I have set up 2 Remote Access (SSL) users who have access to the same network. Where can I specify the PC's that they are allowed to access and no others.
Packet Filter doesn't specify Users as a parameter and Rmote Access allows Networks.

Thanks for your valuable time.

Regards.

This thread was automatically locked due to age.

Parents

0 BAlfson over 16 years ago

The only remote access method that allows you to set up different "classes" of users is IPsec. I've been using L2TP for wide-open access and SSL for "restricted" access because SSL lets you specify the networks/hosts that remote users can access.

In 'Local networks', instead of putting 'Internal (Network)', just put the two PCs they're allowed to access.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 touchwood over 16 years ago in reply to BAlfson

Thanks Bob

Appreciated.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 touchwood over 16 years ago in reply to BAlfson

Thanks Bob

Appreciated.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data