Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 1 subscriber
  • Views 653 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Locking user to specific hosts in Remote Access

touchwood
I know this is probably a typical Newbie type question -

I have set up 2 Remote Access (SSL) users who have access to the same network. Where can I specify the PC's that they are allowed to access and no others.
Packet Filter doesn't specify Users as a parameter and Rmote Access allows Networks.

Thanks for your valuable time.

Regards.


This thread was automatically locked due to age.
Parents
  • 0
    The only remote access method that allows you to set up different "classes" of users is IPsec.  I've been using L2TP for wide-open access and SSL for "restricted" access because SSL lets you specify the networks/hosts that remote users can access.

    In 'Local networks', instead of putting 'Internal (Network)', just put the two PCs they're allowed to access.

    Cheers - Bob
Reply
  • 0
    The only remote access method that allows you to set up different "classes" of users is IPsec.  I've been using L2TP for wide-open access and SSL for "restricted" access because SSL lets you specify the networks/hosts that remote users can access.

    In 'Local networks', instead of putting 'Internal (Network)', just put the two PCs they're allowed to access.

    Cheers - Bob
Children