Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 1 subscriber
  • Views 8124 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSEC Protocol: ESP - Where is it?

Marshall
I'm migrating from an old Netscreen to an ASG 325.  Currently on V7.002.

Anyhow, I'm setting up my VPN tunnels and most of the old tunnels on the Netscreen use ESP Encapsulation in Phase 2.  I'm not able to find that setting on the ASG.  However Article # 120018 which says it applies to V5 and later clearly lists it as an option in the IPSec settings:

"PSec Settings
3.9 - IPSec Mode: Tunnel
3.10 - IPSec Protocol: ESP"

Any help would be awesome!  Thanks in advance.


This thread was automatically locked due to age.
Parents
  • 0
    I've also got a couple of 525's on V6.  Under 'IPSEC VPN' > 'Policies' > 'New' to create a new policy there is the option to set the IPSEC Protocol to ESP.

    Any help would be great.  I'm actually wondering if V7 automatically defaults to ESP...

    Thanks
Reply
  • 0
    I've also got a couple of 525's on V6.  Under 'IPSEC VPN' > 'Policies' > 'New' to create a new policy there is the option to set the IPSEC Protocol to ESP.

    Any help would be great.  I'm actually wondering if V7 automatically defaults to ESP...

    Thanks
Children
Cookie Information Banner