This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

restricting access to https

hi guys.

i've read the documentation, googled and searched this forum, and gone through the interface with a fine toothed comb but for the love of stan i cannot find a way to restrict https access only to spedivic ip addresses.

can anyone point me either to a document or a specific step or two in the ui to configure this properly?

many thanks.

This thread was automatically locked due to age.

Parents

0 drees over 19 years ago

It's a simple matter of creating a rule to allow https access for those sites, then making sure there are no other rules allowing https access for other sites.
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 19 years ago in reply to drees

And making sure the HTTP proxy is not allowing HTTPS traffic for everyone.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 19 years ago in reply to drees

And making sure the HTTP proxy is not allowing HTTPS traffic for everyone.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 InlineFive over 19 years ago in reply to BarryG

Here is what I would consider doing.

1. Create Host associations for the IP addresses you would like to access with HTTPS under Network >> Definitions.
2. Under the Packet Filter >> Rules create rules to allow access from your source internal network(s) to the Hosts you defined in step 1.
3. Create one group for all of the HTTPS entries so you have pretty colors.
4. Ensure that HTTPS is disabled in the HTTP proxy (if you use the proxy).

Manifique!
Cancel
Vote Up 0 Vote Down

Cancel