Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 7 replies
  • Subscribers 1 subscriber
  • Views 1888 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Client-to-Site with ASC without virtual IP ?

ChristoB
I am currently testing Client-to-Site VPN with ASC

ASG220, Version 6.103
ASC Version 8.2

Problem:
I can establish a connection using a virtual IP address in IPSec VPN >> Remote Keys (ASG220) and in the ASC.
I don't get any connection when trying to work without virtual IP.

Reason for the tests: I try to setup a client-to-site VPN with Safenet SoftRemote LT and there I cannot assign a virtual IP (or haven't found a way to do so).

Has anyone any ideas ?

Cheers
Christo


This thread was automatically locked due to age.
Parents
  • 0
    By Netscreen you have first to enable the vitual IP.
    Go to "Options – Global Policy Settings" and enable -->
    "Allow to Specify Internal Network Address"
    Then go to the section "My Identity" and change the setting
    "Virtual Adapter" to required and enter your virtual IP.
    I tested this with version 10.x

    Regards,

    Medic
Reply
  • 0
    By Netscreen you have first to enable the vitual IP.
    Go to "Options – Global Policy Settings" and enable -->
    "Allow to Specify Internal Network Address"
    Then go to the section "My Identity" and change the setting
    "Virtual Adapter" to required and enter your virtual IP.
    I tested this with version 10.x

    Regards,

    Medic
Children
No Data
Cookie Information Banner