Hi,
When using asc with adsl internet providers it works fine. Using a cable operator i receive this error in the asc logfile:
20/08/2005 9:21:23 Disconnect: cause - Manual Disconnect.
20/08/2005 9:21:24 IPSDIALCHAN::start building connection
20/08/2005 9:21:28 IPSDIALCHAN::start building connection
20/08/2005 9:21:28 NCPIKE-phase1:name(RW) - outgoing connect request - main mode.
20/08/2005 9:21:28 XMIT_MSG1_MAIN - RW
20/08/2005 9:21:28 RECV_MSG2_MAIN - RW
20/08/2005 9:21:28 IKE phase I: Setting LifeTime to 5000 seconds
20/08/2005 9:21:28 RW ->Support for NAT-T version - 9
20/08/2005 9:21:28 XMIT_MSG3_MAIN - RW
20/08/2005 9:21:28 IPSDIAL->FINAL_TUNNEL_ENDPOINT:194.144.076.131
20/08/2005 9:21:28 RECV_MSG4_MAIN - RW
20/08/2005 9:21:29 XMIT_MSG5_MAIN - RW
20/08/2005 9:21:29 XMIT_MSG5_MAIN_RESUME - RW
20/08/2005 9:21:30 RECV_MSG6_MAIN - RW
20/08/2005 9:21:30 NCPIKE-phase1:name(RW) - error - PKI ERROR: - Client Error: Verify Certificate with error 2002 ! (unable to get issuer certificate)
20/08/2005 9:21:30
20/08/2005 9:21:30 NCPIKE-phase2:name(RW) - error - cleared by phase1
20/08/2005 9:21:30 IPSDIAL - disconnected from RW on channel 1.
What i found is tha the cable operator blocks some of the incomming ports under the 1024 especially the port 500.
How can i set the incomming certificate above port 1024?
Using release 6002 and asc 8.20 build 69, RW AES
Thanks
This thread was automatically locked due to age.
