This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Technical problem

Hi, i have a wired problem using ipsec.

When i configure VPN tunnels, the data is displayed in WebAdmin and is saved into /etc/wfe/conf/ipsec*, but no tunnel will be established and no configuration data is saved into the files of the ipsec chroot environment. [:S]

Sometimes a "no public interfaces found" appears in the log, but i have eth0 with a rfc-1918 ip, eth1 with ppp0 (dsl) and a official ip address!

ff

This thread was automatically locked due to age.

Parents

0 pablito over 22 years ago

You must have a config problem on one end or both. Look at the log and check what errors are being reported.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 pablito over 22 years ago

You must have a config problem on one end or both. Look at the log and check what errors are being reported.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 FrankFiene over 22 years ago in reply to pablito

I think, this is a middleware problem. The freeswan will not start because no configuration will be moved from /etc/wfe/conf/ipsec* files to /var/chroot-ipsec/etc. Also the X.509 directories are empty in the chroot environment!

Could i run the middleware and see some error messages over ssh?

ff [:S]
Cancel
Vote Up 0 Vote Down

Cancel