Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 1 subscriber
  • Views 517 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Technical problem

FrankFiene
Hi, i have a wired problem using ipsec.

When i configure VPN tunnels, the data is displayed in WebAdmin and is saved into /etc/wfe/conf/ipsec*, but no tunnel will be established and no configuration data is saved into the files of the ipsec chroot environment.  [:S]

Sometimes a "no public interfaces found" appears in the log, but i have eth0 with a rfc-1918 ip, eth1 with ppp0 (dsl) and a official ip address!

ff 


This thread was automatically locked due to age.
  • 0
    You must have a config problem on one end or both.  Look at the log and check what errors are being reported.
      
  • 0 in reply to pablito
    I think, this is a middleware problem. The freeswan will not start because  no configuration will be moved from /etc/wfe/conf/ipsec* files to /var/chroot-ipsec/etc.   Also the X.509 directories are empty in the chroot environment!

    Could i run the middleware and see some error messages over ssh?

    ff [:S]  
Cookie Information Banner