This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VPN Problem

I have e problem with Astaro 3.2.16.
I have estabilisced a VPN connectin betwen 2 astaro firewall. There is a way to ping host PC when ICMP forward on firewall is disabled?
I cannot use NBTSTAT command to host PC because it procude an error HOST NOT FOUND. How i can resolve the problem?

Thanks for help.

lcapecci.

This thread was automatically locked due to age.

Parents

0 Marcel_01 over 22 years ago

uhm... once again please.. you wanna ping from one of the asl's or from a machine in your local/remote subnet? .. and where is the host you want to ping?

/marcel
Cancel
Vote Up 0 Vote Down

Cancel
0 lcapecci over 22 years ago in reply to Marcel_01

I'm able to ping a host pc on remote network from a pc of my network but i can't make a NBTSTAT of the remote PC.
I'm not able to find a PC of remote network from my windows XP PC thru FIND menu.
Cancel
Vote Up 0 Vote Down

Cancel
0 norwich over 22 years ago in reply to lcapecci

Are you using "NBTSTAT -A IPaddress" rather than "NBTSTAT -a MacineName"?
Cancel
Vote Up 0 Vote Down

Cancel
0 lcapecci over 22 years ago in reply to norwich

I have tried the two sintax but nothing.
Cancel
Vote Up 0 Vote Down

Cancel
0 norwich over 22 years ago in reply to lcapecci

That was with a capital A rather than lower case?
Cancel
Vote Up 0 Vote Down

Cancel
0 lcapecci over 22 years ago in reply to norwich

Just tried, nothing
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 lcapecci over 22 years ago in reply to norwich

Just tried, nothing
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 lcapecci over 22 years ago in reply to lcapecci

Another idea ??

Please.
Cancel
Vote Up 0 Vote Down

Cancel
0 DALTEC101 over 22 years ago in reply to lcapecci

We had a smilar issue that we resolved by makeing sure we had the packetfilter set up to allow all traffic from the remote network and our network to talk.
Cancel
Vote Up 0 Vote Down

Cancel
0 lcapecci over 22 years ago in reply to DALTEC101

I've tried your solution, but the problem is not resolved. If i make a rule that permit traffic from/to ANY/ANY it's OK. I don't understand.
Cancel
Vote Up 0 Vote Down

Cancel
0 lcapecci over 22 years ago in reply to lcapecci

After a sleeping night, this morning i have recontrolled all the configuration. My error was in the rules configuration beetwen the two firewall. Corrected theese setting now all right. Thanks all for support. lcapecci
Cancel
Vote Up 0 Vote Down

Cancel