This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Linksys BEFSR41 and Windows 2000 IPSEC

Hi:
Need a quick answer. Are there any known issues with ASL and Linksys devices? I have a Windows 2000 network at one end behind a Linksys BEFSR41 using Win2K ISPEC policies. ASL is at the other end. If I go straight to the @HOME modem on the Win2K side in a HOST-TO-NET configuration it works great to ASL. As soon as I introduce the Linksys at the Win2K end, IPSEC dies. I have ISPEC passthru turned on in the Linksys. Just covering both ends to check....
regards,
Dave Cook

This thread was automatically locked due to age.

Parents

0 Sean S. over 24 years ago

Have you gotten the most recent version upgrade from Linksys? Very important IPSec passthru.
Cancel
Vote Up 0 Vote Down

Cancel
0 Sean S. over 24 years ago in reply to Sean S.

Have you gotten the most recent version upgrade from Linksys? Very important FOR IPSec passthru.
Cancel
Vote Up 0 Vote Down

Cancel
0 Dave Cook over 24 years ago in reply to Sean S.

Hi:
Yes, I'm using 1.39.
Question: How do I setup the Win2K client policy behind the Linksys. Is it Host-to-Net or Net-to-Net? I've tried both with no luck.
D.C.
Cancel
Vote Up 0 Vote Down

Cancel
0 David Lee over 24 years ago in reply to Dave Cook

have you tried putting this win2k box on the dmz of the linksys? (I assume that this model number is the router/switch) I don't know that it would help, but I have had some success resolving ftp issues this way.
Cancel
Vote Up 0 Vote Down

Cancel
0 futziz over 22 years ago in reply to David Lee

Hey !
Does anybody knows something about that issue...
i have the same problem here.. W2K IPSEC client 1.4 with ASL 3.214 at the end. When i debug the IKE proposal, the phase 1 goes well but hte phase 2 fail. I've check all Ipsec pass thru rules and everything is fine. Linksys firmware is 1.44.

any help !!!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 futziz over 22 years ago in reply to David Lee

Hey !
Does anybody knows something about that issue...
i have the same problem here.. W2K IPSEC client 1.4 with ASL 3.214 at the end. When i debug the IKE proposal, the phase 1 goes well but hte phase 2 fail. I've check all Ipsec pass thru rules and everything is fine. Linksys firmware is 1.44.

any help !!!
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Fazil over 22 years ago in reply to futziz

Linksys v1.39 is *NOT* the most current edition.

It's up to 1.44 now.
Cancel
Vote Up 0 Vote Down

Cancel