In discards Lan Interface

Fooc,

make sure to configure Speed and Full Duplex on both Switch and XG side. Also can you share the output from the following commands:

netstat -s

ethtool -S "portname"

You should execute these commands from CLI > Option 5 > Option 3

Thanks

Fooc,

make sure to configure Speed and Full Duplex on both Switch and XG side. Also can you share the output from the following commands:

netstat -s

ethtool -S "portname"

You should execute these commands from CLI > Option 5 > Option 3

Thanks

Thanx man, i will check that.

I made i mistake by posting it in xg forum, it is a sg125, so the cli commands will be different.

Do you advise to allways set the duplex and speed fixed?

Fooc,

it is always a best practice (switch, router, firewall and every network devices) to set the port to fixed speed and mode. This will prevent possible error and reduce the time between the devices to find the correct settings.

I cannot move your thread to UTM9 because you are not a member of that group. Please make sure to sign-in at UTM9 Forum and I will move your thread there. Send me a PM once you requested the access.

Thanks

The thread has been moved here.

Thanks