Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 7 replies
  • Subscribers 2 subscribers
  • Views 2643 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Routing Problem if using two wan interface

amit@careoffice.co.in
Hi
I am testing on with Two wan interface. My scenario is 

I have an internal network with ip address 192.168.2.0
One Wan Interface for internet connection.
And One more WAN2 for other area network ip adress is 192.168.50.0

What is the step by step configuration for the setup of two wan.

I have previously configured with static routing but not successful in working with both network simultaneously.


This thread was automatically locked due to age.
Parents
  • 0
    If you can't reach anything but 192.168.50/60.x when going out WAN2, then you should use Static Routing.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Reply
  • 0
    If you can't reach anything but 192.168.50/60.x when going out WAN2, then you should use Static Routing.

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Children
No Data
Cookie Information Banner