This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

eMule only gets Low ID

Looks like there hasn't been a thread for eDonkey/eMule in quite some time so I thought I'd start one for ASG V7.505.

I have tried so many hundreds of setups but no matter what I do, I only get lowIDs. My current setup is:

eMule TCP
Protocol: TCP
Source: 1:65535
Destination: 9662

DNAT
Source: Any
Destination: External WAN Address
Service eMule TCP
Destination Translation: myemulepc

Packet Filter
Source: any
Service: eMule TCP
Destination: myemulepc
Action: allow

EDIT: I did this for the UDP port as well as the TCP port. Exact same settings with service definition "eMule UDP"

I have even tried packet filters with
any>any>myemulepc

and Full NAT with any service to myemulepc.

Still the packet capture shows a returned message from the server stating "port 9662 is not reachable. please check your network config" then switches to lowID.

Any ideas?

I have also turned off Intrusion Protection for now until I get this working.

This thread was automatically locked due to age.

Parents

0 Krycek over 15 years ago

Might be stupid, but did you add an exception to your windows firewall (or other software firewall you might beusing?)

Also: Did you check your intrusion Prevention Log? Maybe you can find anything there?
Cancel
Vote Up 0 Vote Down

Cancel
0 Astaronator over 15 years ago in reply to Krycek

Turned off Windows Firewall. No other firewall installed.
And there was only a very few number of blocked port scans. I mean like 2-3 in a 10 hour span.

Thanks for the input though!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Astaronator over 15 years ago in reply to Krycek

Turned off Windows Firewall. No other firewall installed.
And there was only a very few number of blocked port scans. I mean like 2-3 in a 10 hour span.

Thanks for the input though!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data