This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

vlan and firewall

on 2 port eth0 = 192.168.33.1 and eth1 = 192.168.33.2 are member in vlan 1on eth1 is a host x.x.33.5
and on eth0 is host x.x.33.8 konekted
so I made a Firewall rule, that this 2 host are blogged, but it does not work always is a connection availebille.

What I am doing wrong?

This thread was automatically locked due to age.

Parents

0 RFCat_vk_01 over 17 years ago

Hi,
your problem would appear to be one of addressing. You have 2 seperate interfaces in the same address space. Make eth1, 192.168.34.1 and try again.

Ian M
Cancel
Vote Up 0 Vote Down

Cancel
0 michapdm over 17 years ago in reply to RFCat_vk_01

Sorry I undestand it so, that in a vlan in a switched enviroment, the networkclass musst be the same. if all nodes are in the same networksegment then will vlan work.
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 17 years ago in reply to michapdm

Each interface (real or VLAN) needs to have it's own subnet.
If you have it this way, please re-describe the configuration.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 17 years ago in reply to michapdm

Each interface (real or VLAN) needs to have it's own subnet.
If you have it this way, please re-describe the configuration.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 michapdm over 17 years ago in reply to BarryG

"Each interface (real or VLAN) needs to have it's own subnet."
Is this on the astaro so? normally is a Vlan a broadcast domain. Please look here
http://www.petri.co.il/csc_setup_a_vlan_on_a_cisco_switch.htm

On a 3com or cisco switch you can implement accesslist.
Is this also possible on the astaro.
Cancel
Vote Up 0 Vote Down

Cancel