This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Mewbee question to Full NAT

Hello,

newbee not mewbee!

I am testing around with full NAT V7003:

- Site to Site VPN.
- Internal Server wants to connect to remote server 192.168.1.200
- Internal Server should not be visible with its original IP. It should
be visible with an adress out of the standard VPN pool: 10.242.4.10.

Could anybody help me with full nat?

Yours

Holger

This thread was automatically locked due to age.

Parents

0 BarryG over 18 years ago

The VPN pool is for VPN clients, not for site to site VPNs.

Your INT server will be seen as it's original IP, unless you do some sort of NAT (if this is possible).

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 18 years ago

The VPN pool is for VPN clients, not for site to site VPNs.

Your INT server will be seen as it's original IP, unless you do some sort of NAT (if this is possible).

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data