This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Webadmin remote access

Hi,

I am using ASG 7.***

I want to access remote the Webadmin console.

What have I done:
DNAT Rule.
Traffic Source: Any
Traffic Service: webadmin
Traffic Destination: external-ip
NAT Mode: DNAT
Destination: internal-ip
Destination Service: webadmin

Then created packet filter:
Allow Any->webadmin->internal_ip

I tried to connect from work to https://:4444 but will not connect.

Internal network is allowed for webadmin in management interface (dashboard)

What went wrong or what did I forgot?

This thread was automatically locked due to age.

Parents

0 Atticka over 18 years ago

OR, you can do this....

Goto "management -->web admin settings -->access control"

Under access control, add the WAN interface to the "allowed Networks" list, mine is set to "ANY" (this way I can access the web interface from both the WAN and LAN sides).

No additional rules or routing needed.
Cancel
Vote Up 0 Vote Down

Cancel
0 Damibla over 18 years ago in reply to Atticka

Okay thanks......

Lets go for it.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Damibla over 18 years ago in reply to Atticka

Okay thanks......

Lets go for it.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data