This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

QoS how to?

i run ASL version 5.202 and the use of QoS or more better named port prioritizing is quite unclear on how to be setup. i have turned QoS on on my internet link (external) and done speed settings and setup some packet filter rules but have yet to see anything happen much. help?

This thread was automatically locked due to age.

Parents

0 bce over 20 years ago

it's not unclear.
it's quite simple:
enable qos on external nic:
specify your bandwidth.
and then say in packet filter rules: allow low priority or allow or allow high priority.
that's it!

also throw a glance at this post:
http://www.astaro.org/showthreaded.php?Cat=&Number=45448&page=&view=&sb=5&o=&vc=1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 bce over 20 years ago

it's not unclear.
it's quite simple:
enable qos on external nic:
specify your bandwidth.
and then say in packet filter rules: allow low priority or allow or allow high priority.
that's it!

also throw a glance at this post:
http://www.astaro.org/showthreaded.php?Cat=&Number=45448&page=&view=&sb=5&o=&vc=1
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 mark105 over 20 years ago in reply to bce

i thought thats how it was done just didnt seem to work too well when i first tryed, seems to be running ok now though.
Cancel
Vote Up 0 Vote Down

Cancel