This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Masq Problem with virtual interfaces

I have 5 IP's assigned on the WAN side of my firewall with one inteface card this is set as xxx.xxx.xxx.97 the others 98,99,100 etc are additional addresses on the interface card. I want to enable masq fron internal to xxx.xxx.xxx.100 but the only intefaces shown are internal,dmz and 97 is there a reason for this ?

This thread was automatically locked due to age.

0 cyclops over 21 years ago

masquerading can only be applied to real interfaces, afaik.

Greetings
cyclops
Cancel
Vote Up 0 Vote Down

Cancel
0 omega over 21 years ago in reply to cyclops

Assuming we are talking about V5, this is only true for simple masquerading.
But selecting DNAT/SNAT you can easily masq on virtual interfaces.
Cancel
Vote Up 0 Vote Down

Cancel
0 SilverSurfer over 21 years ago in reply to omega

OK Thanks Guys

I thought I did this in ASL4 but now am not so sure

Thanks Again
Cancel
Vote Up 0 Vote Down

Cancel