This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

V4 - Making it work

New install of V4 (V3 was working fine) Two interfaces whihc both work. Astaro can see the outside world and can update. Inside lan cannot access outside world. Switch on HTTP proxy then full access is able. Any clues?

This thread was automatically locked due to age.

Parents

0 Simon Shaw over 22 years ago

What do you mean precisely when you say the inside LAN can't see the outside ? Can you ping external addresses at all ? Ensure ICMP Ping is allowed.
Or are you just talking web ?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Simon Shaw over 22 years ago

What do you mean precisely when you say the inside LAN can't see the outside ? Can you ping external addresses at all ? Ensure ICMP Ping is allowed.
Or are you just talking web ?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 iconism over 22 years ago in reply to Simon Shaw

At present there is no access to the outside world in any protocol. POP, SMTP, WEB. Web is funtional only when the http proxy is enabled. I may be missing something simple. Both interfaces functional, enabled a packet filter for any in both directions. Nothing works..
Cancel
Vote Up 0 Vote Down

Cancel
0 jader_01 over 22 years ago in reply to iconism

If you have nonroutable IPs (private 192.168.y.x) in your LAN, you have to masquerade your LAN to your external interface.

Erik
Cancel
Vote Up 0 Vote Down

Cancel
0 iconism over 22 years ago in reply to jader_01

I was under the impression that the base install performed all routing once the internal and external interfaces where allocated and the packet filter. What is missing therefore is a define route?
Cancel
Vote Up 0 Vote Down

Cancel
0 jader_01 over 22 years ago in reply to iconism

Have a look at the excellent manual Astaro gives us for free here:

RTFM

NAT/Masquerading starts at page 112.

Erik
Cancel
Vote Up 0 Vote Down

Cancel