This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Geting Terminal Services to work with Netopia router

I have Terminal Services (admin mode) installed on a Win2k server. A Netopia R910 router is plugged into the network and connected to an ADSL modem. The router has the basic firewall set enabled. I added a UDP and TCP port 3389 input filter to my list of filters in the basic firewall settings but I still can not terminal serve into this network. Am I overlooking something?

This thread was automatically locked due to age.

Parents

0 wjl over 23 years ago

Hi Sam,

does the Netopia connect to ASL with IPsec VPN? If so, this shouldn't be a problem at all...

Greets,
Wolfgang
Cancel
Vote Up 0 Vote Down

Cancel
0 Samantha over 23 years ago in reply to wjl

No, not using VPN. Terminal Serve straight to the IP address.
Cancel
Vote Up 0 Vote Down

Cancel
0 lanman over 23 years ago in reply to Samantha

You also need to setup a port map on the netopia under NAT - Show Change Server List
User service other and set the port to 3389

Private IP the internal servers ip
Public is your WAN IF IP
Cancel
Vote Up 0 Vote Down

Cancel
0 Samantha over 23 years ago in reply to lanman

That did the trick LanMan. Tkx.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Samantha over 23 years ago in reply to lanman

That did the trick LanMan. Tkx.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data