Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 2 subscribers
  • Views 2443 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

problem in Clustering

iseikco
Hi, 
I'd set active/active clustering in utm. according to the "system status" tab in ha configuration it seems that the whole traffic load is passing through MASTER and slave is not working..
how can i be sure about load balancing in UTM?


This thread was automatically locked due to age.
Parents
  • 0
     Are you seeing anything that would indicate a problem in the High Availability log?

    nothing strange:-(
    I even disconnect the master node for redirecting traffics to pass the slave node. but nothing happened! The Clustering configuration on both devices are the same and both nodes are shown in system status tab but it seems no traffics pass the slave;-(
Reply
  • 0
     Are you seeing anything that would indicate a problem in the High Availability log?

    nothing strange:-(
    I even disconnect the master node for redirecting traffics to pass the slave node. but nothing happened! The Clustering configuration on both devices are the same and both nodes are shown in system status tab but it seems no traffics pass the slave;-(
Children
No Data
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?