This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

problem in Clustering

Hi,
I'd set active/active clustering in utm. according to the "system status" tab in ha configuration it seems that the whole traffic load is passing through MASTER and slave is not working..
how can i be sure about load balancing in UTM?

This thread was automatically locked due to age.

0 BAlfson over 10 years ago

Unless your license is for two nodes, you cannot do Active/Active.

Cheers - Bob

Sorry for any short responses. Posted from my iPhone.

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 iseikco over 10 years ago in reply to BAlfson

Hi, thanks for your reply
Unless your license is for two nodes

Is it "upgrade cluster node" option in "myutm.sophos.com" portal?
I'd do this for my both devices.
Cancel
Vote Up 0 Vote Down

Cancel
0 Scott_Klassen over 10 years ago

After doing this in the portal, did you re-download the license from myutm, then apply it to your utm?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 iseikco over 10 years ago in reply to Scott_Klassen

Yes, i did that and It was working properly but after upgrading to 9.310, it this problem happened.
I'd first upgrade the Slave node, and after that, the master. because of it the master node is now slave and the slave is showing as master. Can this issue cause slave node not working now?
Cancel
Vote Up 0 Vote Down

Cancel
0 vilic over 10 years ago

What is the cluster operation mode (Management -> High Availability -> Configuration) ?
Cancel
Vote Up 0 Vote Down

Cancel
0 iseikco over 10 years ago in reply to vilic

It's cluster(active-active)..
Cancel
Vote Up 0 Vote Down

Cancel
0 Scott_Klassen over 10 years ago

the master node is now slave and the slave is showing as master. Can this issue cause slave node not working now?
Shouldn't matter, as long as the units are the same rev. If you wanted to, you could always power off the current Master, so the other one becomes Master again. Are you seeing anything that would indicate a problem in the High Availability log?

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 iseikco over 10 years ago

Are you seeing anything that would indicate a problem in the High Availability log?

nothing strange:-(
I even disconnect the master node for redirecting traffics to pass the slave node. but nothing happened! The Clustering configuration on both devices are the same and both nodes are shown in system status tab but it seems no traffics pass the slave;-(
Cancel
Vote Up 0 Vote Down

Cancel

problem in Clustering

Submitted a Tech Support Case lately from the Support Portal?