This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Option 3 Router - DHCP options

DHCP option 3 is routers and in theory it should take a list of ip addresses in order of preference which will be distributed to clients as the default gateway. not only does opton 3 not allow entry of more than 1 ip address but it doesnt change the default gateway ip.. any ideas?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 10 years ago

You do not mention what version you're running. Always do so when asking for help. Be aware that DHCP options were broken in 9.204 and 9.205, fixed in 9.206.

You should be able to distribute multiple IPs by using a Network Group instead of Host object.

After adding the new DHCP option, make certain that you enable it by moving the slider to the right (it'll turn green).

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 10 years ago

You do not mention what version you're running. Always do so when asking for help. Be aware that DHCP options were broken in 9.204 and 9.205, fixed in 9.206.

You should be able to distribute multiple IPs by using a Network Group instead of Host object.

After adding the new DHCP option, make certain that you enable it by moving the slider to the right (it'll turn green).

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 DavisDarvish over 10 years ago in reply to Scott_Klassen

You do not mention what version you're running. Always do so when asking for help. Be aware that DHCP options were broken in 9.204 and 9.205, fixed in 9.206.

You should be able to distribute multiple IPs by using a Network Group instead of Host object.

After adding the new DHCP option, make certain that you enable it by moving the slider to the right (it'll turn green).

sorry .. i assumed that you would assume i was using the latest.. I am on Current firmware version: 9.309-3

still have that problem.. option 3 if i understand it properly should allow me to specify more than one default gateway...
Cancel
Vote Up 0 Vote Down

Cancel

Option 3 Router - DHCP options

Submitted a Tech Support Case lately from the Support Portal?