This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PPPOE with MTU higher than 1492 (rfc-4638)

Hi,

It looks like MTU values higher than 1492 are not supported on my current version 9.201-23

Can anyone please advise if this is supposed to be like this as I read it was already implemented on previous versions.

(Support PPPoE RFC 4638 (MTU > 1492))

If not, is there any way to set the MTU value permanently on the ppp0 interfaz?

thanks in advance

This thread was automatically locked due to age.

Parents

0 BAlfson over 11 years ago

Run the second set of commands first to learn the REF for the ppp0 interface, and then use that in the cc change_object command.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 11 years ago

Run the second set of commands first to learn the REF for the ppp0 interface, and then use that in the cc change_object command.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data