This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

weird error

i'm seeing this in a clients utm screen
Fairnet
Ethernet Up Error

link state is error. I can't find anything int he laogs..ipconfig shows no errors neither does ethtool. Any ideas?

This thread was automatically locked due to age.

Parents

0 VelvetFog over 11 years ago

I am getting the same thing on the new UTM 9.2 router that I just built.
My WAN link is up, and passing traffic, but I get the red Link Error status.
The error is intermittent, it comes and goes.
I swapped out first the Ethernet cable, then the NIC, but the error is still there.
I am reluctant to put this new router in as my primary household router until I get this fixed.
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 11 years ago in reply to VelvetFog

I think you need to visit the 9.2b site and have a look at a couple of the threads on the issues with NICs, what NICs are you running and getting the error on?

Ian
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 RFCat_vk_01 over 11 years ago in reply to VelvetFog

I think you need to visit the 9.2b site and have a look at a couple of the threads on the issues with NICs, what NICs are you running and getting the error on?

Ian
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data