Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 2 subscribers
  • Views 562 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Silly doubt!

r00tm4n
Hi all,

I am going to try to configure Active/Active HA two UTMs.
I read the document to do so but i sudennly came to a question,
After configuring the first machine (master), do i have to setup the
IPs in the slave or just use the same IPs as the master?



Looking forward to heraring from you.


Até já.


This thread was automatically locked due to age.
Parents
  • 0
    You do not have to configure anything on the slave(s). Just out them on factory reset an plug them together via eth3.

    Make sure the slave(s) have the same or a slightly lower firmware version as the master.

    ----------
    Sophos user, admin and reseller.
    Private Setup:

    • XG: HPE DL20 Gen9 (Core i3-7300, 8GB RAM, 120GB SSD) | XG 18.0 (Home License) with: Web Protection, Site-to-Site-VPN (IPSec, RED-Tunnel), Remote Access (SSL, HTML5)
    • UTM: 2 vCPUs, 2GB RAM, 50GB vHDD, 2 vNICs on vServer (KVM) | UTM 9.7 (Home License) with: Email Protection, Webserver Protection, RED-Tunnel (server)
Reply
  • 0
    You do not have to configure anything on the slave(s). Just out them on factory reset an plug them together via eth3.

    Make sure the slave(s) have the same or a slightly lower firmware version as the master.

    ----------
    Sophos user, admin and reseller.
    Private Setup:

    • XG: HPE DL20 Gen9 (Core i3-7300, 8GB RAM, 120GB SSD) | XG 18.0 (Home License) with: Web Protection, Site-to-Site-VPN (IPSec, RED-Tunnel), Remote Access (SSL, HTML5)
    • UTM: 2 vCPUs, 2GB RAM, 50GB vHDD, 2 vNICs on vServer (KVM) | UTM 9.7 (Home License) with: Email Protection, Webserver Protection, RED-Tunnel (server)
Children
No Data
Cookie Information Banner