This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

(tagged) VLAN with only one NIC ?

Hello there,

is it possible to create 2 VLANs on one NIC, which is already in use (webadmin, port 4444)?

I'm using a small Box from Zotac (via dualcore, 4gb), which works very well.
Now i want to use a hp procuve switch with 2 VLANs, one multihomed port which is used by the astaro.

i Think i have to use an unused nic, right?
So can i realize a VLAN-Setup with only one nic (onboard)?

Thx in advance,

Manuel

This thread was automatically locked due to age.

0 matthias.schmidt over 13 years ago

Hi Manuel,

You can change the existing interface type from "ethernet standard" to "ethermnet vlan" (just tested with 8.300), and then add other vlan interfaces. But be carefull because you can easily lock yourself out by doing this.

Kind regards,

Matthias
Cancel
Vote Up 0 Vote Down

Cancel
0 ManuelKarl over 13 years ago in reply to matthias.schmidt

ok, ill first have to setup an test-env, with my current production-astaro i'll not try to test and lock the network... ;-)

Thx, i'll try.
Cancel
Vote Up 0 Vote Down

Cancel
0 RFCat_vk_01 over 13 years ago in reply to ManuelKarl

Hi,
you will need to access the wedadmin via the external interface so that you don't lock yourself out.

Ian[[:)]][[:)]]
Cancel
Vote Up 0 Vote Down

Cancel
0 matthias.schmidt over 13 years ago in reply to RFCat_vk_01

you will need to access the wedadmin via the external interface so that you don't lock yourself out.

I think the problem is, that there is no external interface [:)]
Cancel
Vote Up 0 Vote Down

Cancel