This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Uplink balancing troubles!

Maybe somebody can help me?
Have 2 ASG V8, on both two uplink interface, eth 0 on both ASG in same provider network and that is a problem!
When first interface (eth0) down on ASG1 bat eth0 on ASG2 don’t wall ASG1 use eth1, bat route table say ASG1 89.105.145.86(ASG2 IP) you wind on 89.105.145.66 (eth0). Soooooo bad, have some ideas about that?
If I’m disable eth0 on ASG1 all is fine.
[:S]

This thread was automatically locked due to age.

Parents

0 da_merlin over 13 years ago

Uh nice setup [[:)]] Interface routes overrule Default Gateway routes.

Please change the Netmask of eth0 to 32/255.255.255.255 on both ASGs. Then it should work.

Yes, Default Gateway is not within the Netmask anymore. Normally this would fail. However we install routes with "onlink" flag, so this works [[:)]]

Cheers
Ulrich
Cancel
Vote Up 0 Vote Down

Cancel
0 totram over 13 years ago in reply to da_merlin

Ulrich nice WORK!
Am tested your post and it is work!
Thank you!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 totram over 13 years ago in reply to da_merlin

Ulrich nice WORK!
Am tested your post and it is work!
Thank you!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data