Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Internal management port question

I have two 425's clustered, when the internal management port is on, the status of the clustering is UNLINKED and I noticed the CPU is high on the unit. When I turn off the management port the status on units is ACTIVE ACTIVE. is this correct? and if so, how would I access the ASG from the management port if it is turned off?


This thread was automatically locked due to age.
Parents
  • I haven't seen that behavior.  Do you have the same ethernet port connected from both 425s to the management port subnet?  Or maybe this is just an incorrect message - have you looked in the High Availablity log to confirm this is happening?  I think the HTTP log shows transactions handled by the different clustered devices - what do you see there?

    Cheers - Bob
Reply
  • I haven't seen that behavior.  Do you have the same ethernet port connected from both 425s to the management port subnet?  Or maybe this is just an incorrect message - have you looked in the High Availablity log to confirm this is happening?  I think the HTTP log shows transactions handled by the different clustered devices - what do you see there?

    Cheers - Bob
Children
No Data