This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Internal management port question

I have two 425's clustered, when the internal management port is on, the status of the clustering is UNLINKED and I noticed the CPU is high on the unit. When I turn off the management port the status on units is ACTIVE ACTIVE. is this correct? and if so, how would I access the ASG from the management port if it is turned off?

This thread was automatically locked due to age.

0 BAlfson over 15 years ago

I haven't seen that behavior. Do you have the same ethernet port connected from both 425s to the management port subnet? Or maybe this is just an incorrect message - have you looked in the High Availablity log to confirm this is happening? I think the HTTP log shows transactions handled by the different clustered devices - what do you see there?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 James Shakour over 15 years ago

I opened a ticket with Astaro and they seem to think a database is corrupt, b/c when I reboot it the issue goes away for about a day and then the same thing happens.

Thanks for the reply Bob!
Cancel
Vote Up 0 Vote Down

Cancel