This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Need some clarifications on multiple external adresses

Our ISP supply us with a subnet:

***.***.***.160 - ***.***.***.167

They use ***.***.***.161 as the default gateway, and we use ***.***.***.162 as the primary IP.

How do you configure this in ASG?

This thread was automatically locked due to age.

Parents

0 BarryG over 15 years ago

Hi, set Astaro's External address as .162.

If needed, then you can create new virtual interfaces as 'additional IP addresses' on the External interface, and DNAT incoming traffic as needed.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BarryG over 15 years ago

Hi, set Astaro's External address as .162.

If needed, then you can create new virtual interfaces as 'additional IP addresses' on the External interface, and DNAT incoming traffic as needed.

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 erucolindo over 15 years ago in reply to BarryG

Yes, that was my understanding. Do I set my .162 address with mask /29 or /32?

And do I add addresses one by one or can I add the whole range?

Thanks for your answer.
Cancel
Vote Up 0 Vote Down

Cancel