This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ha active-passive

Hello all,

I've installed an Active-passive cluster.

So on my first node i can see :" Node 1, master, active"

On my second node i see : "Node 2, slave, active"

I'm in active-passive mode... Is it normally that my second node diplay "Active" ?

Thanks for your reply

This thread was automatically locked due to age.

Parents

0 BAlfson over 12 years ago

Look on the last tab of High Availability to see whether you are in cluster or hot standby mode. Also if your license doesn't specify more than one node then you can't go into cluster active-active mode.

Cheers - Bob

Sorry for any short responses! Posted from my iPhone.

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 12 years ago

Look on the last tab of High Availability to see whether you are in cluster or hot standby mode. Also if your license doesn't specify more than one node then you can't go into cluster active-active mode.

Cheers - Bob

Sorry for any short responses! Posted from my iPhone.

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data