This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SNMP problem - snmpwalk

ASG220:I've enabled SNMP request. After receiving many lines from command snmpwalk -c public -v 1 i receive the message "Timeout: No Response from ". Note that the same request to Astaro Security Linux 5.201 works fine.

Livio.

This thread was automatically locked due to age.

Parents

0 MarkMurphy over 19 years ago

Turns out Intrustion Protection rule was blocking. Turned that off and SNMP works now. It was a rule in the SNMP rules set
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 19 years ago in reply to MarkMurphy

Which rule?

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 MarkMurphy over 19 years ago in reply to BarryG

Group Informational messages
INFO web bug 0x0 gif attempt - ID 2925

and

Rules for SNMP protocol
SNMP request udp - ID 1417
SNMP public access udp - ID 1411

You could also turn off the IPS on the internal interface.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 MarkMurphy over 19 years ago in reply to BarryG

Group Informational messages
INFO web bug 0x0 gif attempt - ID 2925

and

Rules for SNMP protocol
SNMP request udp - ID 1417
SNMP public access udp - ID 1411

You could also turn off the IPS on the internal interface.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 BarryG over 19 years ago in reply to MarkMurphy

Thanks. Sounds like this should be mentioned on the SNMP settings page, and added to the docs & KnowledgeBase.

Barry
Cancel
Vote Up 0 Vote Down

Cancel