This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Radius Authentication for HTTP proxy

I've followed the instructions for setting up Radius authentication for my http proxy, but it still does not seem to work.

When I disable authentication, http proxies just fine.  When I enable, it hangs and I get a "Page Cannot Be Displayed" message, although I see that DNS resolves the server.

I have no rules enabled in the packetfilter, as I'm using the squid proxy.

I have IAS set up and configured on Win2000.  User has the dial in permission, and I set up the http policy.

My main concern is that I cannot diagnose the source of the problem.  I don't know where the logging is taking place for this procedure.  Is there a log to look for in Astaro when I ssh into it?

It appears that it never makes any request to my Win2000 radius server.  How can I be sure of this?

Thanks in advance.

This thread was automatically locked due to age.

0 DocJones over 23 years ago

Also, when I set up local authentication and configure a few users, I get the same problem.

Am I supposed to be seeing a authentication window pop up on the screen?

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
0 tom_01 over 23 years ago in reply to DocJones

hi doc,

yes, the browser should prompt you for a username and password on the first HTTP request. If you do not get this, make sure that the proxy is entered in the browsers configuration (no transparent mode).

/tom
Cancel
Vote Up 0 Vote Down

Cancel