update 9.600

Hi

Please check out the discussion on the phased release of 9.6, over in the thread, here: https://community.sophos.com/products/unified-threat-management/f/general-discussion/110176/9-6-release-still-not-showing

Kind regards,

Briain

Hi Briain,

Thanks for the reply,

I already read that link and also the release notes of the 9.600, What I found a bit strange is that update 9.600 is not ready for the auto update and now update 9.61 is out there!!

Thanks 

Hi AreshAreshi

I think we now just have to assume (as was also speculated in that thread) that there were some minor issues with 9.600 (and I have indeed noticed a few comments about it on this forum) and thus it was decided not to progress 6.000 from phase 1 to phase 2 release (as in the Up2date distribution) but to instead fix the issues, rename the fixed version 9.601 and then re-start the phased release process. I must stress that I have absolutely no inside information, so the above is merely guesswork (I was going to say 'an educated guess', but in my case, that would have been a somewhat fraudulent claim). :-)

Bri

Hi AreshAreshi

I think we now just have to assume (as was also speculated in that thread) that there were some minor issues with 9.600 (and I have indeed noticed a few comments about it on this forum) and thus it was decided not to progress 6.000 from phase 1 to phase 2 release (as in the Up2date distribution) but to instead fix the issues, rename the fixed version 9.601 and then re-start the phased release process. I must stress that I have absolutely no inside information, so the above is merely guesswork (I was going to say 'an educated guess', but in my case, that would have been a somewhat fraudulent claim). :-)

Bri