Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Server reboots when network cable plugged in!

Hello!

I have a big problem with my sophos box!
The computer is brand new, asrock motherboard with 3 Intel nics in the pci-express slots.
I have ran it without any problems for two weeks with an old hard drive I had. Tonight I replaced the hard drive with an ocz agility 3 ssd and reinstalled the box.
When everything was setup it started and network cables plugged in it started to reboot all the time! 
I thought the ssd was faulty first but without the network cable plugged in to the nic that has the dsl-connection on it it works flawlessly! As soon as I plug the cable in the box reboots within a few seconds!

I switched back to the old harddrive (not an ssd) and the computer works even with the network cable plugged in.
The network cables to the second nic that is my "lan" card is connected without problems all the time with the ssd plugged in.

This issue will make me mental sick soon! I have never had such a weird problem before! 
- With ssd plugged in I can't connect my internet connection because then the computer restarts.

I can have both internet connection and ssd plugged in while booting into bios/efi but can not run sophos properly.. 

It feels like when the network card initializes the issues starts and computer reboots when the ssd is plugged in..

Can it be something like a addressing collision or something?

Please help me out, this will run me insane!


This thread was automatically locked due to age.
Parents Reply Children
  • Obviously, UTM doesn't like that hardware at all.  Very possible, since the driver set installed is very limited and many are quite generic.  It is possible that there's an address collision as well. Check the kernel and boot messages logs for errors.


    It is so weird.. The erhernetcard works and is connected all the time. It is only when I connect the cable to the dsl modem the t reboots, like it reboots when trying to get ip from dhcp or something..
    The ssd works flawlessly without the network cable to the net installed, so it doesn't look like a driver issue because everything works when the nerwork cable is detached to the net.. When that cable is detached, I can log in and configure the box without problems via the web interface.. 

    So weird..

    Going to connect logs after work today and see that if I can see any issues in the logs..