Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DHCP fails after DHCPOFFER (VLAN)

I have the UTM configured as the DHCP-server for both the 'regular' traffic and for a VLAN. The latter has its own DHCP-server on the UTM, on the interface for the VLAN.

The log shows the DHCPDISCOVER and DHCPOFFER, but there doesn't seem to be a request from the client after that.

[FONT="Courier New"]2015:05:18-22:03:04 utm dhcpd: DHCPDISCOVER from 00:a6:96:b6:8b:21 via eth0.666
2015:05:18-22:03:04 utm dhcpd: DHCPOFFER on 192.168.6.100 to 00:a6:96:b6:8b:21 via eth0.666[/FONT]

Setup:

UTM (with virtual NIC for VLAN 666) -> Netgear GS108T (port tagging) -> WAP*

* I've tried two old access points I had laying around: a DLINK DIR-655 and a Netgear WNR2000v3.

It seems that either the DHCPOFFER doesn't make it to the client, or the DHCPREQUEST is lost somewhere. (I haven't had a chance to do a tcpdump yet.)

Any ideas?


This thread was automatically locked due to age.
Parents
  • On a hunch I connected a client directly to the switch (on the port dedicated to my guest VLAN 666). Lo and behold - the DHCPOFFER now reaches the client and its getting an IP-address in the correct subnet (as well as default gateway, etc.).

    So... apparently the wireless router is blocking the DHCPOFFER. Any idea how to get either one of these to relay DHCP?

    -  DLINK DIR-655
    -  Netgear WNR2000v3
Reply
  • On a hunch I connected a client directly to the switch (on the port dedicated to my guest VLAN 666). Lo and behold - the DHCPOFFER now reaches the client and its getting an IP-address in the correct subnet (as well as default gateway, etc.).

    So... apparently the wireless router is blocking the DHCPOFFER. Any idea how to get either one of these to relay DHCP?

    -  DLINK DIR-655
    -  Netgear WNR2000v3
Children
No Data
Share Feedback
×

Submitted a Tech Support Case lately from the Support Portal?