Guest User!

You are not Sophos Staff.

Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 6 replies
  • Subscribers 2 subscribers
  • Views 11204 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Unable to re-install UTM 110/120 "no appliance hardware has been detected"

lorenzoboss
Hi,
after a Hard Disk failure, i replace the HD of a UTM 110/120, i'm trying to install a fresh image, but i'm getting "no appliance hardware has been detected".
Obviously i'm using the Hardware ISO image !
I tried to install it with the Software ISO image, installation finish fine, but after the reboot Ethernet interface doesn't work (no line goes up).

Thanks for help
Lorenzo


This thread was automatically locked due to age.
Parents Reply
  • 0 in reply to lorenzoboss
    There are hardware checks at installation time. If you use a different hardware (harddisc, RAM NICs, ...) the installer will not recognize the box anymore.

    You can use the software image but NIC sorting is most likely incorrect.
    Which revision of UTM120 do you use?

    Hint: try 'if up eth0' and for all NICs to check which NIC is right one.
Children
No Data